The Weighbridge 010: Oil Soars, Copper Slips

endless metals logo

The Weighbridge | No.010

weekly market intelligence data – 27 October 2026

Teal corrugated fence at the Endless metal recycling yard in Onehunga, painted with "Recycle today for a greener tomorrow"

Oil Soars,
Copper Slips

Oil reaches a four-year high, copper retreats,
and a stronger NZ dollar takes the shine off
gains in other metals.

NZD/USD
0.5693
▲ +0.5%
5 Week
high

metals at a glance
Steel

US$410/t
■ HOLDING
Price holding firm

Copper

US$14,368/t
▼ −0.5%
5 week low

Aluminium

US$3,044/t
▲ +0.5%
Modest recovery

Nickel

US$15,846/t
▲ +2.9%
Prices rebound

Lead

US$1,925/t
▲ +1.9%
4 week high

The Big Picture

Oil has taken centre stage this week, with Brent crude jumping 6.1% to almost US$116 a barrel, its highest level in more than four years. Renewed concerns about tensions involving Iran and Saudi Arabia have raised fears of further disruption to global oil supplies.

Copper has slipped 0.5% to around US$14,368/t after briefly reaching a five-week low. The end of strike action at Chile’s Centinela mine, alongside an agreement at Escondida, has eased concerns about copper supply.

Elsewhere, aluminium has edged up 0.5%, nickel has recovered 2.9%, and lead has climbed 1.9% to a four-week high. However, aluminium and nickel remain under pressure from longer-term concerns about global supply.

The NZ dollar has strengthened for a second consecutive week, reaching 0.5693 against the US dollar. That matters for local recyclers because a stronger NZ dollar reduces the value of internationally traded metals when converted into our currency. Attention now turns to interest rate decisions from the Reserve Bank of New Zealand and the US Federal Reserve on 28 October, which could influence the next movement in currencies and commodity markets.

Oil surges, metals show mixed gains, and a stronger NZ dollar limits the benefit for local sellers.

What this Means for Your Scrap

It’s a mixed week for scrap metal values. Nickel and lead have recovered, aluminium is holding steady in NZ dollar terms, and copper has eased. The stronger NZ dollar is reducing the local benefit of international price gains.

Steel last confirmed international benchmark remains around US$410/t, with Turkish market reports suggesting prices are holding firm. However, the stronger NZ dollar may put slight pressure on local steel and whiteware values.

Copper has slipped 0.5% internationally, with the stronger NZ dollar increasing the decline to approximately 1% in local currency terms. Copper pipe, cable and wire may see slightly softer values, although prices remain high by historical standards.

Brass generally follows movements in copper. With copper easing this week, clean brass, fittings and gunmetal may experience some downward pressure.

Aluminium has recovered slightly in US dollars, but the stronger NZ dollar has largely offset that gain. Local values for extrusion, cast aluminium and cans are likely to remain relatively steady.

Nickel has rebounded following reports of possible production cuts in Indonesia. This could provide some support for stainless steel grades such as 304 and 316, although the broader supply outlook remains uncertain.

Lead has climbed to a four-week high, rising approximately 1.3% in NZ dollar terms. This could provide some support for lead-acid battery recycling values after several quieter weeks.

Check before you visit!  Use our online calculator anytime to check prevailing prices

KEY DRIVERS & WHAT TO WATCH

Oil at a four-year high. Brent crude jumped 6.1% to almost US$116 a barrel as tensions involving Iran and Saudi Arabia raised fears of supply disruption. Higher oil feeds straight into freight and shipping costs, which can squeeze margins right through the metal supply chain.

Oil supply remains a concern. Watch for developments in the Middle East, particularly around shipping through the Strait of Hormuz. Any disruption could push fuel and freight costs higher, affecting businesses well beyond the energy sector.

Copper’s next move depends on demand. With the immediate threat of Chilean strikes reduced, attention is shifting to industrial demand, US trade policy and whether copper can hold its recent price levels.

Indonesia could influence nickel prices. Proposed production cuts may help support nickel, but the market still faces forecasts of excess supply. The key question is whether reduced production will be enough to improve prices.

Aluminium needs stronger demand. Chinese exports and returning smelter production are keeping supply plentiful. A meaningful recovery may depend on stronger manufacturing and construction activity.

Interest rates could move the NZ dollar. Decisions from the Reserve Bank of New Zealand and US Federal Reserve on 28 October could affect exchange rates. A stronger NZ dollar generally means lower local returns when international metal prices remain unchanged.

Steel buyers are watching Turkey. Turkish mills remain an important indicator of international scrap demand. Fresh confirmed prices will help establish whether the market is holding steady or beginning to shift.